The driving device adopts the active magnetic magnet coupling installed directly on the motor shaft, and the pump room is completely closed. The rotating structure of the impeller with magnet on the pump shaft indirectly driven by magnetic coupling is compact, safe and energy-saving. The sturdy and durable structure of the pump body, the contact part of the liquid is made of stainless steel, so the pump body is sufficient to withstand the weight of the pipe and low mechanical impact.

Installation and use of stainless steel magnetic pump:
1. The pump should be installed horizontally, not erect, and the plastic pump body shall not bear the weight of the pipeline. for the occasion of vertical installation of special requirements, the motor must face up.
2. When the suction level is higher than the pump axis line, open the suction pipe valve before starting. If the suction level is lower than the pump axis line, the pipe should be equipped with bottom valve.
3, should be checked before use, the motor blade rotation should be flexible, no jam, no abnormal sound, each fastener should be fastened.
4. Check whether the rotation direction of the motor is consistent with the steering mark of the magnetic pump.
5. After the motor starts, slowly open the outlet valve, wait for the pump to enter the normal working state, and then adjust the discharge valve to the required opening.
6. Before stopping working, you should close the discharge valve, and then close the suction valve.

The main points to be noticed in the operation of stainless steel pump are as follows:
1. Make preparations before overhauling and disassembling the stainless steel magnetic pump, understand the pump structure, read the relevant inspection materials, prepare the spare parts, prepare the necessary disassembly and assembly tools, and prepare the necessary safety protection tools.
2. The inspection and repair of stainless steel magnetic pump should be carried out by professionals, the correct use of disassembly and disassembly tools and the correct use of safety protective equipment in the process of maintenance and disassembly.
3. when overhauling and disassembling stainless steel magnetic pumps, they must be handled gently and must not be disassembled or disassembled forcefully, so as not to cause unnecessary equipment.
Damage and personal injury.
4. The spare parts after disassembly and before assembly must be disposed of and kept properly so as to avoid the loss and loss of stainless steel magnetic pump parts.